KOTH centers ??

[OLDFOX]

KOTH centers in TFD ,

I've made a map with three levels of tunnels is it possible to have the KOTH center show up just on the second level ??
I've set the KOTH center to -16 but it still shows up from the survace to the thrid level can it be done .

All so how do you set the wind direction in the med
The wind speed is set to 50 so its should be pritty windy
If i want the wind to blow N-E or S-E how do i enter this in the med and will it change the direction that the clouds go
It'll look a bit daft the wind blowing north and the clouds are going south.

[LadyHawke]

I'm not sure this will work, but try setting the KOTH Center marker at the same Z value and Blink Group of your tunnel level.

Also, to set the wind direction, just type in the degrees in the box below the wind speed box in the General Information Menu. North is 0 (degrees), with each degree moving clockwise. For example: 90 (degrees) would be East, 180 (degrees) would be South, 270 (degrees) would be West.

[Edited on 12-19-2002 by LadyHawke]

[OLDFOX]

Thanks LH i'll try that

Cheers mate .

[OLDFOX]

I've been told the KOTH Center will show up on all levels so the only way to do it is not to have any tunnel sections above or below the KOTH Center and put a wall around it on the surface this way the only time you enter the KOTH Center is on the second level.

A BIG thank you goes to Smokingbud@4:20 .

just compleated his name bro lol

[Edited on 12/23/02 by Edward]